Guide for 9, 9.7 and 10.1 inch (item numbers F and G)

Installing a 9" – 10.1" – 9.7" radio Bilmedie radios with product numbers F and G

This guide shows you how to install your Bilmedie radio in the 9", 10.1" or 9.7" size. Radios with product numbers starting with F or G are supplied with a separate screen and radio fascia.

You can find the product number on the sheet inside the box. Check the first letter of the product number, for example F385 or G010.

1. Remove the old radio

Start by removing the old radio from the car so you can access the vehicle’s original connectors and wiring.

  • Switch the car off completely before you begin
  • Carefully remove the panels around the radio
  • Unscrew the old radio
  • Disconnect all plugs from the old radio

2. Fit the screen into the radio fascia

Radios with product numbers F and G are supplied with a separate screen and radio fascia.

The screen must therefore be fitted into the radio fascia before installation in the car.

  • Carefully place the screen into the radio fascia
  • Align the screw holes
  • Secure the screen using the supplied small screws
  • Tighten the screws carefully – avoid overtightening

3. Identify the type of radio cable

Compare your cable with the image below and find the type that matches your car:

  • Left: With CANBUS box
  • Centre: With white connector, without CANBUS box
  • Right: Without CANBUS
Bilmedie cable types

4. Connect the cables to the new radio

Connect the black end of the radio cable to the back of the new radio. Then connect all white plugs to the radio.

  • Connect the black main plug to the back of the radio
  • Connect all white plugs to the relevant ports
  • Connect the CANBUS box if included

5. Connect the signal cable

Remember to connect the white plug from the signal cable to the back of the radio. This ensures a stable connection to your phone.

6. Fit the FM adapter if required

  • Locate the radio’s round antenna connector
  • Connect the FM adapter
  • Check that it is fitted correctly

7. Fit the GPS and WiFi antenna

  • The GPS antenna can be fitted if needed
  • The WiFi antenna can be fitted if needed
  • Your phone often provides the best signal

8. Set up CANBUS and steering wheel controls

  • Connect the radio to WiFi
  • Open Factory Settings
  • Use PIN code: 000000, 1234, 3378, 8878, 8888 or 16176699
  • Select the correct CANBUS profile
  • Set up the steering wheel controls via the SWC app

9. Set Up Apple CarPlay or Android Auto

  • Open the T-Link or Z-Link app
  • Follow the on-screen setup
  • Approve the connection on your phone

10. Troubleshooting

  • Open Factory Settings
  • Try Factory Reset
  • Try System Update
  • The radio must be connected to WiFi

Need help?

If you're having trouble with the installation, you can contact our support team.

Contact support